Galvanically isolated gate driver for GaN transistors

Called STGAP2GS the wide body SO-8W packaged single-channel driver can work with rails up to 1.2kV.

The package is 5.8mm long by 10.3mm across pins tips, with 7.5mm between leg roots on either side of the isolation barrier.

A separate supply (above), or dual supplies (left) if a negative off-voltage is required at the gate, is required on the output side. This can be at up to 15V.

Output capacity of 2A source and 3A sink, and there are separate source and sink outputs to allow different series resistors to be added to independently optimise turn-on and turn-off.

The input-side supply can be 5V or 3.3V, and the signal input has hysteresis for snappy switching.

High-to-low and low-to-high transistion delays are matched through the device. Maximum propagation delay input to output is 70ns across the -40 to +125°C operating junction temperature range with a 5V input supply, and 90ns at 3.3V. Typical 25C figures are 42ns at 5V and 55ns at 3.3V.

Output rise and fall times are 30ns with a 4.7nF load.

“Transient immunity of ±100V/ns over the full temperature range guards against unwanted transistor gate change,” said ST. “The driver features built-in system protection including thermal shut-down and under-voltage lock-out optimised for GaN technology.”

On top of this, internal circuits keep the output drivers in a safe state (keeping the external device off) until all voltages are properly established, and a watchdog turns off the external device if communication across the isolation barrier is lost.

There are two inputs, allowing either polarity of PWM to be applied.

A demonstration board, EVSTGAP2GS (pictured) combines the STGAP2GS with ST’s SGT120R65AL 75mΩ, 650V enhancement-mode GaN transistors.

These include adjustable dead-time generation for the half-bridge output stage, and so accept a simple PWM input.

On-board isolated (5.2kV) dc-dc converters provide the secondary side with power, and gate drive can be set at +6V/0V or +6V/-3V.

Consumer and industrial applications are foreseen, including in servers, factory-automation, motor drivers, solar power, wind power, home appliances and wireless chargers.

Find the STGAP2GS web page here and its evaluation board here.

—
—